Baymak Jetinox 112-50LT Booster Pump, Horizontal Tank, 6 Floors, 6 Apartments

Baymak Jetinox 112-50LT Booster Pump, Horizontal Tank, 6 Floors, 6 Apartments

• An original DAB pump is used. Features a stainless steel casing. Shipped pre-assembled and ready to use.
• Can draw suction from depths of up to 8 meters. (Capacity varies depending on suction depth.)
• The flexible pipe is short, so it takes up less space.
• The tank does not rust because it does not come into contact with water and has an oven-painted finish.
• Shipped with a 1-meter plug-in cable.

Baymak Jetinox 112-50LT Technical Specifications

• Mechanical Seal: Carbon / Ceramic / NBR
• Impeller Material: Technopolymer
• Pump Casing: Stainless Steel
• Pump Shaft: Stainless Steel
• Venturi, Diffuser: Technopolymer
• Protection Class: IP 44
• Insulation Class: F
• Max. Fluid Temperature: +40 °C
• Max. Operating Pressure Rating: 8 Bar
• Operating Pressure Range: 3.5–5 Bar
• Connection Size: 1" / 1"
• Motor Power: 1.5 HP / 1.1 kW
• Total Weight: 28 kg
• Voltage: 220 V

Baymak Jetinox 112-50LT Important Notes

• Baymak booster pump initial start-up must be carried out by an authorized Baymak service center. Otherwise, the warranty will be void.
• Transport the Baymak Jetinox 112-50LT only in its original packaging, observing the warnings on the box.
• For the installation of the Baymak Jetinox 112-50LT, it is recommended to draw suction at least 30 cm above the tank floor to prevent foreign matter in the water (sand, etc.) from damaging the product.
• The Baymak booster pump must not be connected to draw directly from the city mains; it must draw from a storage tank.
• Do not interfere with the expansion vessel valve; it is charged with compressed air when there is no water in the pump.
• The pressure switch has been factory-set; do not make any adjustments.
• It is recommended to install the Baymak booster pump in a well-ventilated location where the temperature does not exceed 40 °C.
• Install the suction and discharge pipes with clamps so that the load is transferred to the wall.
• If the Baymak Jetinox 112-50LT fails to move after being idle for a period, loosen the shaft at the rear of the motor.
• If the water inside the unit is to be completely drained, this must be done in an environment below 0 °C. If the unit will not be used for an extended period, draining is recommended to prevent internal corrosion.
• Install a switch proportional to the current, paying attention to the information on the Baymak Jetinox 112-50LT label.
• Under no circumstances allow anyone other than authorized service personnel to work on the unit.
• For the installation piping: if metal pipe is used, the inlet/outlet diameters must be the same; if plastic pipe is used, the next size up should be selected.
• The suction line should be as short as possible (maximum 6 m) and made with the fewest possible fittings.
• Never run the Baymak Jetinox 112-50LT dry. Otherwise the mechanical seal, impeller, and electric motor will burn out and the warranty will be voided.
• We recommend using the Baymak Jetinox 112-50LT with a protection panel to guard against electrical faults.